200-2 |
Precast Concrete Sewer Manhole |
Manhole backfill from
the top of pipe bedding to roadway subgrade shall be either sand compacted to 95% or structural backfill |
201-1 |
Precast Concrete Shallow Manhole |
|
203-1 |
Brick Sewer Manhole |
Only applicable
when adjusting a manhole to grade per Std. Plan 205-1. |
208-1 |
Breaking Into Existing Manholes |
|
210-2 |
610mm (24") Manhole Frame and
Cover - Locking Type |
Agency identification
is not required per note 3. For note 7, inspections prior to shipment will not be required. A compÂliance certification delivered to the Engineer from the supplier will be acceptable. |
211-1 |
Manhole Frame and
Cover- Pressure Type |
|
212-1 |
Anchor System for Pressure Cover |
|
221-1 |
Pipe Anchors and Backfill Stabilizers |
|
222-1 |
House Connection Sewer |
Type 'B' profile is
not allowed. All connection sewers shall extend 5' outside of street right-of-way. Note 3 is revised to allow only VCP in all cases. However, in hillside residential areas, ABS truss pipe or PVC truss pipe may be used for pipes 1O" in diameter and smaller. Also, 4" connection sewers may be used for single family homes. |
223-1 |
House Connection Remodeling |
Case 'H' is not
allowed. Note 6 is not applicable. |
224-1 |
Supports for Conduits Across Trenches |
In Case 2, Note 1,
the word "slides" shall be replaced with the word "sides." |
225-1 |
Blanket Protection for Pipes |
Applies to new pipes
in addition to existing pipes.
|